混流泵3、安装基础：要求土质坚实牢固。? 4、水泵安装时，必须保证泵轴的水平位置。? 5、进水管末端应浸入水平面以下一米左右，混流泵，但须离开泥底半米左右。? 6、水泵安装好后，计算允许吸上高度和扬程，在水位稳定的条件下，要求为规定数量值的0.8~1.2倍范围，否则水泵不会正常运行I.Installation Principle?1. InstallationHeight: Considering the height according to the rainy season or dry season.The suctionvacuumheight cannot be higher than the adsorbing height.?2. InstallationLocation:The location is better to close to the water source as p ?ascan.It should be notonlykeeping the safety but also shortening the water inlet pipe and reduce theheadloss 混流泵?8、填料处漏水太多?The padding is?leaking water too much?1、填料压得太松?2、填料装置不好?3、填料大小不一或磨损过多?4、填料质量差，密封性不好?5、轴套磨损太多?1.The padding is pressed too loose?2.The padding does not assemble well?3.The padding is not of niform size or it?wears too much?4.The padding is with bad quality and?tightness?5.?1、上紧压盖到适应程度?2、调整填料搭口，混流泵价格，使之错开一定角度而不在一个方向?3、更换填料?4、更换符合要求的石棉填料?5、更换轴套?1.Tighten the gland up to suitable degree?2.Adjust the padding jiont up to some?angle not in the same direction.?3.Change the padding?4.Change the suitable asbestos padding?5.Change the axle sleeve.（一）HW型混流泵由泵体、泵盖、叶轮、泵轴和轴承体等主要零件构成。I. HW Mixed-flowpump is composed of pump casing， pump cover， impeller， pump spindle and bearingbody mainly.水泵转向? ? ? ? ?从水泵进水口看叶轮为逆时针方向旋转（即箭头所示方向旋转。）V. ? ?Pump Diversion? ? ?Look from inlet of pump， the impeller isturning clockwise(turning as the direction indicated by rotation arrow) 混流泵-混流泵价格-金石泵业(商家)由泰安金石泵业有限公司提供。泰安金石泵业有限公司（www.tajsby.cn）为客户提供“水泵,泥浆泵,混流泵,轴流泵,渣浆泵”等业务，公司拥有“金石泵业”等。专注于污水泵、杂质泵等行业，在山东 泰安 有较高度。欢迎来电垂询，联系人：刘经理。 产品：金石泵业供货总量：不限产品价格：议定包装规格：不限物流说明：货运及物流交货说明：按订单
