混流泵?8、填料处漏水太多?The padding is?leaking water too much?1、填料压得太松?2、填料装置不好?3、填料大小不一或磨损过多?4、填料质量差，密封性不好?5、轴套磨损太多?1.The padding is pressed too loose?2.The padding does not assemble well?3.The padding is not of niform size or it?wears too much?4.The padding is with bad quality and?tightness?5.?1、上紧压盖到适应程度?2、调整填料搭口，使之错开一定角度而不在一个方向?3、更换填料?4、更换符合要求的石棉填料?5、更换轴套?1.Tighten the gland up to suitable degree?2.Adjust the padding jiont up to some?angle not in the same direction.?3.Change the padding?4.Change the suitable asbestos padding?5.Change the axle sleeve. 混流泵?5、水泵有杂音或振动?There is noise?in pump or the pump is vibrating?1、轴中心没有对正?2、轴弯曲轴承磨损过大?3、叶轮平衡性差?4、地脚螺栓松动?5、装置不当?6、叶轮局部阻塞?7、吸水高度太高、发生汽蚀?8、泵内掉进杂物?1.The axile center is not aligning?2.The axile is bend, the bearing wears?much?3.The balance of impeller is not good?4.The foundation bolts are loose?5.The assembly is improper?6.Part of the impeller is blocked?7.The suction head is too high to produce?cavitation?8.There are sundries in pump.?1、找正?2、校正或更换轴承?3、进行静平衡试验和调整?4、拧紧?5、检查机组?6、消除杂物?7、降低安装位置减低安装高度?8、清除杂物?1.Calibrate?2.Calibrate it or change the bearing?3.Do the static balancing test and adjust?it?4.Tighten it?5.Check the pump unit?6.Remove the sundries?7.Reduce the installation site to reduce?the installation height?8. Remove the sundries（一） ? 型号说明：以250HW-8为例：? 250—泵进（出）水口直径为250毫米。? 8—泵总扬程为8米。III. ? ?Type Instruction:Take 250HW-8 for an example:250-The diameter of inlet /outlet of pump is 250mm.8-The total head of pump is 8m. 混流泵-大流量混流泵-金石泵业(商家)由泰安金石泵业有限公司提供。行路致远，砥砺前行。泰安金石泵业有限公司（www.tajsby.cn）致力成为与您共赢、共生、共同前行的战略伙伴，更矢志成为污水泵、杂质泵较具影响力的企业，与您一起飞跃，共同成功! 产品：金石泵业供货总量：不限产品价格：议定包装规格：不限物流说明：货运及物流交货说明：按订单
