PRODUCT INFORMATION
PRODUCT DEION: XYLAN 1014/P01931E DEEP MED. BLUE 524
PRODUCT CODE: P01931E
GENERAL INFORMATION:
The primary end use for this coating is: DRY FILM LUBRICATING COATING
PRODUCT SPECIFICATIONS:
SOLIDS, theoretical: 30.00 ± 2.0% by wt., 19.88 ± 2.0% by vol.
DENSITY, theoretical: 9.00 ± 0.2 lb/gal, 1.08 ± 0.02 Kg/liter
COVERAGE, theoretical: 318.87 sq.ft./gal.@ 1 mil, 7.24 sq.m./Kg.@ 25 microns
VISCOSITY, as shipped: 25 - 35 SECONDS ZAHN 3 S90 CUP at 77°F 25°C
TYPICAL PROPERTIES:
FLASH POINT: 85°F, 29°C
VOLATILE ORGANIC CMPDS: 6.42 lb./gal., 770.40 grams/liter
PREPARATION OF PARTS FOR COATING:
Parts must be free of dirt, oil and other soils to achieve good adhesion and defect free coatings. The
following are the recommended substrates and substrate preparations used with this coating:
SUBSTRATES: MOST METALS, SOME CERAMICS AND PLASTICS
PREPARATION: DEGREASE LIGHT GRITBLAST RECOMMENDED ZINC PHOSPHATE ON
STEEL RECOMMENDED MAY BE USED OVER ETCHED ZINC PLATE.
PRIMERS: MAY BE USED OVER XYLAR 1, 2 OR XYLAN 4090 SERIES PRIMERS.
PREPARATION OF COATING MATERIAL:
Mix containers thoroughly by shaking or stirring until any solid material on the bottom has been
eliminated. Best results are obtained when the coating temperature is 65-90°F 18-32°C. Adjust
viscosity, if necessary, using the recommended thinner and an accurate Zahn Viscosity Cup. Other
viscosity cups may also be used. Add thinner in increments of 2% until proper viscosity is achieved.
Low viscosity produces runs and sags and low film thickness. High viscosity produces poor
sprayability and uneven appearance. Any dried coating or dirt may be removed by passing the
coating through a 100-200 micron filter.
APPLICATION VISCOSITY: 25 - 40 SECONDS ZAHN 2 S90 CUP AT 77°F 25°C
VISCOSITY ADJUSTMENT: NMP/XYLENE - 2:1 OR SOLVENT 99B, AS NEEDED.
OTHER INFORMATION: AVOID CREATING FOAM WHILE MIXING.
