电梯前室压差传感器消防楼梯间前室压力传感器批发
技术参数
压力形式: 表压,压差
测量范围: 0~500pa
耐 压:1000PA
精 度: 1级
动作压力: 前室/走道动作压力:27.5Pa,复位压力:17.5PA
楼梯
消防楼梯间前室压力传感器批发
电梯前室压差传感器消防楼梯间前室压力传感器批发
技术参数
压力形式: 表压,压差
测量范围: 0~500pa
耐 压:1000PA
精 度: 1级
动作压力: 前室/走道动作压力:27.5Pa,复位压力:17.5PA
楼梯间/前室动作压力:45Pa,复位压力:35PA
显围:-0000~9999字,四位数字
输出方式:开关信号(24VDC/3A)
工作电压: 24VDC
介质温度:-20~85℃
密封等级:IP65
过载能力:150%FS
外形尺寸:172*112*60
重 量:350g
前室微压差传感器
根据消防要求加压送风时应使防烟楼梯间压力、前室压力、走道压力、房间压力,同时还要保证各部分之间的压差不要过大,造成开门困难影响疏散。当火灾发生时,机械加压送风系统应能够及时开启,防止烟气侵入作为疏散通道的走廊、楼梯间及其前室,以确保有一个、畅通无阻的疏散通道和环境,为安全疏散提供足够的时间逃生,本公司生产的HLB-016压力传感完全可以满足消防规定要求

压力传感器消防楼梯间前室压力传感器批发
加压后的风再分别通过每层的百叶窗或风阀送往每层的前室或楼梯间。当消防前室或楼梯间的通风压力或压差超过设定值(前室25~30Pa,楼梯间40-50Pa)时,位于每层的压力传感器顺即时发出信号报警输入旁通泄压阀控制箱,旁通泄压阀控制箱根据压力传感器的信号打开旁通泄压阀,旁通泄压阀打开后,部分加压送风机送往风管的风通过旁路风管经过旁通泄压阀回到风机前端(红色箭头位置)

The compressed air is then sent to the front room or stairwell of each floor through the shutters or the air valve. When the ventilation pressure or pressure difference in the fire chamber or Stairwell exceeds the set value (25 ~ 30 PA in the Front Chamber and 40-50 PA in the Stairwell) , the pressure sensor located on each floor immediately sends a signal to the by-pass pressure relief valve control box, the by-pass Pressure Relief Valve control box opens the by-pass pressure relief valve according to the signal of the pressure sensor, part of the pressurized air supply fan to the air duct through the Bypass Air Duct by-pass Relief Valve back to the Fan Front (Red Arrow ition)
(作者: 来源:)