混流泵
（一）HW型混流泵由泵体、泵盖、叶轮、泵轴和轴承体等主要零件构成。
I. HW Mixed-flow
pump is composed of pump casing, pump cover, impeller, pump spindle and bearing
body mainly.
水泵转向
从水泵
不锈钢混流泵供应价
混流泵
（一）HW型混流泵由泵体、泵盖、叶轮、泵轴和轴承体等主要零件构成。
I. HW Mixed-flow
pump is composed of pump casing, pump cover, impeller, pump spindle and bearing
body mainly.
水泵转向
从水泵进水口看叶轮为逆时针方向旋转（即箭头所示方向旋转。）
V. Pump Diversion
Look from inlet of pump, the impeller is
turning clockwise(turning as the direction indicated by rotation arrow)
2、水泵起动后有一股水就不出水了
After starting ,
the pump only send one stream water then no water runs out
1、吸入的水中有过多气泡
2、吸水管中窝存空气
3、吸水管或连接处垫料不严密有进气现象
4、底阀或叶轮有水草杂物填塞
1.There are too many bubbles in the
indrawn water
2.There is air in the suction pipes
3.The paddings in connected parts are
imprecision and produces leaking phenomenon
4.There are waterweeds and sundries
filled in the bottom valve or impeller
1、检查进水管末端是否在水平面以下一米左右
2、排除空气
3、高速垫料，填塞缝隙拧紧螺栓
4、消除水草杂物
1.Check the end
of water inlet pipe if it is under the water surface at one meter
2. Remove the
air
3.Add padding to
fill the gaps and then tighten the bolts
4.Clear the
waterweeds and sundries.
4、耗用功率太大
The power
consumption is too large
1、转速太高
2、传动轴弯曲
3、填料压得太紧
4、轴承磨损或损坏
5、叶轮和前盖摩擦
6、皮带太紧
1.The rotate speed is too high
2.The drive shaft is bend
3.The padding is too tight
4.The bearing is worn out
5.Impeller clashes the front cover
6.The belt is too tight
1、降低转速
2、校直
3、拧松压盖螺栓或将填料取出打扁一些
4、更换轴承
5、调整叶轮端面轴向间隙
6、适应放松
1.Reduce the rotate speed
2.Straightening
3.Loose the cap blot or take our the
padding and make it more flat
4.Change the bearing
5.Ajust the end play of impeller end face
6.Loose the belt to suitable degree
（作者： 来源：）
