混流泵
3.
Installation Base:The soil texture should be firm and solid.
4.
During installation, keep the pump axile in horizontal p ition.
5.The end of
water inlet pipe should be
农业混流泵销售
混流泵
3.
Installation Base:The soil texture should be firm and solid.
4.
During installation, keep the pump axile in horizontal pition.
5.The end of
water inlet pipe should be immersed under water in about one meter and far away
from the end of mud in about half meter.
6.After installing the pump,calculate the
suitable suction height and head.Under the stable water level condition,
3、水泵出水量不足
The waer yield
of water is not enough
1、进水管路或叶轮有水草杂物
2、转速过低
3、输水高度过高
4、泵盖及叶轮磨损间隙过大
5、填料进气
6、马力不足
7、进水管口插入水中深度不够
1. There are waterweeds and sundries in
inlet pipes or impeller
2.The rotate speed is too low
3.Water delivery height is too high
4.The attrition gap between pump cover
and impeller is too large
5.The padding is air in
6.The horsepower is not engough
7.The depth of inlet pipe under water is
not enough
1、清除水草杂物
2、调整转数
3、降低输水高度
4、用纸垫调整间隙至正常
5、压紧或更换填料
6、加大马力
7、增加插入水中深度至一米左右
1.Clear the waterweeds and sundries
2.Ajust the rotate speed
3.Reduce the water delivery height
4.Add paper washers to adjust the gaps
5.Compact or change padding
6.Increase the horsepower
7.Make the depth of inlet pipe under
water to one meter
4. 水泵的安装位置应满足允许吸上真空高度的要求，基础必须水平、稳固，保证动力机械的旋转方向与水泵的旋转方向一致。
5. 若同一机房内有多台机组，机组与机组之间，机组与墙壁之间都应有800mm以上的距离。
6. 水泵吸水管必须密封良好，且尽量减少弯头和闸阀，加注引水时应排尽空气，运行时管内不应积聚空气，要求吸水管微呈上斜与水泵进水口联接，进水口应有一定的淹没深度。
（作者： 来源：）
